Processing of inner holes

Scope of application

Disk type, shaft type workpiece.

Reloading run-out

6 seconds (wire harness 3m / s)

Single piece total run-out

Product cutting time + 6 seconds

Storage drive mode

Speed regulation motor drive

location mode

Sensor detects the positioning

Workpiece positioning accuracy

±0.03

Control system

Domestic/Wistron/Import/ HUST

Transportation belt material warehouse

Speed regulating motor, gear, chain, conveyor belt, drum, aluminum profile

Product replacement needs to change the part

Barn limit mechanism adjustment and hand claw

Characteristic

One tow two truss manipulator + CNC lathe + double conveyor belt bin, adapt to the length of less than 50 round stem type and plate products, two lathes processing at the same time, improve efficiency.

Required electrical conditions

Power supply: 3-phase four-wire 380V; voltage fluctuation range: ± 10%; frequency: 50 HZ;

gas source is required: 0.6 Mpa.

On-site environmental requirements

Ambient temperature: -10~50°C; relative humidity: 20%~75%; vibration: vibration acceleration <0.5g; electrical cabinet must be grounded, grounding resistance<1; no corrosive gases at the work site; workshop foundation: conventional cement floor treatment.